FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
- 11. Brake system
   11.1. A technical characteristics
   - 11.2. Forward brakes
      11.2.1. Replacement brake колодок
      11.2.2. Support replacement
      11.2.3. Replacement of a brake disk
   + 11.3. Back brakes
   11.4. Adjustment of a manual brake
   11.5. Removal of air from brake system
   + 11.6. Antiblocking system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

11.2. Forward brakes

11.2.1. Replacement brake колодок

THE GENERAL DATA

Forward brake

1 – an arm of a support,

2 – a support,

3 – brake колодки,

4 – the piston,

5 – a brake disk,

6 – скоба

The prevention
Simultaneous replacement of all brake колодок forward brakes if at least one of them wears out till the minimum thickness is recommended.

PERFORMANCE ORDER

1. To weaken nuts of fastening of forward wheels.

2. To lift and fix in front of the car, to remove forward wheels.

3. Cautiously to pick up a screw-driver and to take скобу (it is specified by an arrow) fastenings of a support of a brake.

4. By means of a key for internal шестигранников 7 mm to unscrew two directing fingers (marksman) of a support.

5. To disconnect sockets of wires of the gauge of deterioration brake колодок.

6. To disconnect a support from the holder and to suspend it to a body by means of a wire (without unscrewing of connection of brake hoses).

7. To take from a support internal brake колодку and external brake колодку from directing колодок.

8. Cautiously to press the piston in a support by means of a corresponding wooden core, being careful not to damage an elastic casing of the piston. In case of need it is possible to remove preliminary a little a brake liquid from a tank.

9. To check up a condition of a brake disk and an elastic casing of the piston.

10. To establish internal brake колодку (an arrow at the left) in a support and to press into the piston a spring (the marksman on the right) internal колодки.

11. To establish external brake колодку in directing a support.

12. To establish a support in directing and to screw up two directing fingers of a support, tightening their moment of 20 Nanometers.

13. To establish on a corresponding place скобу fastenings of a support of a brake.

14. In the same way to replace brake колодки in the second forward brake.

15. To establish wheels, to lower the car and to tighten nuts of fastening of wheels.

16. Some times strongly to press a brake pedal to result in contact brake колодки with a brake disk.

17. In case of need to add quantity of a brake liquid in a tank.