FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Forward brakes
   - 11.3. Back brakes
      11.3.1. Replacement brake колодок
      11.3.2. Removal and support installation
      11.3.3. Replacement of a brake disk
   11.4. Adjustment of a manual brake
   11.5. Removal of air from brake system
   + 11.6. Antiblocking system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c


11.3.1. Replacement brake колодок
THE GENERAL DATA
The prevention

It is recommended to replace simultaneously all brake колодки both back brakes at achievement of the minimum thickness at least with one of brake колодок. It is necessary to use brake колодки specified mark and type.

PERFORMANCE ORDER
1. To weaken nuts of fastening of back wheels.
2. To check up, whether the manual brake is included.
3. To lift and fix a back part of the car on supports and to remove back wheels.
4. To disconnect a cable of a manual brake from the lever of a back suspension bracket.
5. To weaken a back bolt of fastening of a support (it is specified by an arrow) to the holder, holding with a flat key (is specified by an arrow) directing finger of a support.
6. To unscrew and take a forward bolt of fastening of a support to the holder, holding with a flat key directing finger of a support.
7. To turn a support upwards concerning the holder (on back to a fastening bolt).
8. To take brake колодки.
9. Cautiously to press the piston (it is specified by an arrow) in the cylinder of a support by means of corresponding wooden бруска, paying attention not to damage an elastic casing of the piston.
10. To check up:
     – A condition of a casing of the piston;
     – A condition of a surface of a support;
     – A condition of a brake disk;
     – Absence of traces вытекания a brake liquid.
11. To establish new brake колодки.
12. To turn a support (on back to a fastening bolt).
13. To insert a plate protecting from vibration (if it is used).
14. To tighten the corresponding moment bolts of fastening of a support to the holder.
15. To hook on a cable of a manual brake for the lever of a back suspension bracket.
16. To check up, whether the brake disk can freely rotate at the released pedal of a brake.
17. To establish back wheels and to lower the car.
18. To tighten nuts of fastening of back wheels the corresponding moment.