FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
- 9. A steering
   9.1. A technical characteristics
   - 9.2. Service and repair
      9.2.1. Removal and installation of steering transfer
      9.2.2. Dismantling and assemblage of steering transfer
      9.2.3. Removal and steering wheel installation
      9.2.4. A steering wheel centering
      9.2.5. Removal and installation of the lock of blocking of a steering column
      9.2.6. Removal and installation of a steering column
      9.2.7. Dismantling and assemblage of a steering shaft
   + 9.3. A steering with the hydraulic booster
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c


9.2.7. Dismantling and assemblage of a steering shaft
THE GENERAL DATA

Regulator of height of installation of a steering column

Dismantling

PERFORMANCE ORDER
1. To remove a casing from an artificial material from a steering wheel nave.
2. To unscrew a nut of fastening of a steering wheel.
3. To insert a key into the lock of ignition and to establish it in position "I".
4. To remove a steering wheel.
5. To weaken top tightening an adjusting bolt.
6. To unclench a regulator, having inserted between its cut an edge of a screw-driver and to remove the bottom bearing.
7. To unscrew a bolt of the case of a regulator on 5 mm and to take a shaft from a steering column.
8. To remove from a shaft a spring, a washer and the bottom bearing.
9. In the bottom part of a shaft to remove the nylon plug and a spring ring.
10. To remove the multipurpose switch.
11. To press a clip and to take a drum of the blocking lock of a steering wheel.
12. To unscrew bolts of fastening of the switch of ignition and to take it together with a plait of electric wires.
13. To remove a regulator of installation of height of a steering column. At regulator dismantling it is necessary to be careful, as the spring is in a tension.
14. To squeeze out from a steering column the top bearing.

Assemblage

PERFORMANCE ORDER
1. To check up a condition of elements of a steering column. To check up, whether the cut site of a shaft is covered by oil or greasing.
2. To clamp in a vice a steering wheel shaft, to establish on a shaft the bottom nylon ring on distance 54±1 mm from the bottom end face of a shaft.
3. To establish a regulator of installation of height of a steering column.
4. To establish the bottom bearing in the regulator plug.
5. To establish the top bearing in the case of a steering column.
6. To establish the switch of ignition and the multipurpose switch.
7. To establish a spring and a washer on a shaft.
8. To insert a shaft into the case of a steering column.
9. To tighten the screw of fastening of a regulator of height of a steering column.
10. To establish on the end of a shaft a steering wheel, to tighten a nut of fastening and to establish a casing from an artificial material on a steering wheel nave.