Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
- 14. An electric equipment
14.1. A technical characteristics
14.2. Safety locks and the relay
14.3. Electronic blocks of management
14.4. System of the central blocking
14.5. System of indexes of turns
14.6. The fuel computer
14.7. Additional control system
- 14.8. The generator
14.8.1. Removal and generator installation
14.8.2. Dismantling and generator assemblage
14.8.3. Replacement of brushes of the generator and a pressure regulator
14.8.4. The basic malfunctions of the generator
14.8.5. Tension adjustment клинового a belt
+ 14.9. A starter
+ 14.10. A windscreen screen wiper, knot of indexes and a headlight
14.11. Removal and installation of a combination of devices
14.12. External and internal illumination
+ 14.13. An other electric equipment
+ 14.14. Electroschemes
14.8.2. Dismantling and generator assemblage
| THE GENERAL DATA |
Generator Bosch
|
1 pulley of the fan,
2 – a forward cover, 3 – a rotor, 4 – the bearing, 5 – статор, |
6 – the rectifier, 7 – a back cover, 8 – щеткодержатель, 9 – an electronic regulator Pressure |
Generator Lucas
|
1 pulley of the fan,
2 – a forward cover, 3 – a rotor, 4 – the bearing, 5 – статор, |
6 – the rectifier, 7 – a back cover, 8 – щеткодержатель, 9 – an electronic regulator Pressure |
Generator Motorola
|
1 pulley of the fan,
2 – a forward cover, 3 – a rotor, 4 – the bearing, 5 – статор, |
6 – the rectifier, 7 – a back cover, 8 – щеткодержатель, 9 – an electronic regulator Pressure |
In the course of generator repair it is necessary to adhere to following instructions:
– The diodes placed in the generator, are sensitive to a heat; in case of need their replacements in soldering process it is necessary to hold their conclusions with metal tweezers which take away heat from a soldering iron sting, and also to limit to a necessary minimum soldering time;
– It is necessary to avoid use of not earthed electric soldering irons as in case of damage of their isolation they will cause breakdown выпрямительных generator diodes;
– In the course of control tests of the generator of pressure of a food should not exceed 14В;
– In the course of check выпрямительных diodes it is possible to use a direct current the pressure, not exceeding 24 In;
– For cleaning of details it is necessary to use exclusively gasoline; at once after cleaning of details (especially windings) it is necessary to drain them a stream of compressed air.