FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      + 3.2.3. Removal and installation of the engine without a transmission
      3.2.4. Ventilation system картера
      - 3.2.5. Greasing system
         3.2.5.1. Removal and installation oil картера
         3.2.5.2. Removal and installation of the oil pump
         3.2.5.3. Dismantling of the oil pump
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c


3.2.5.2. Removal and installation of the oil pump
THE GENERAL DATA

The oil pump

1 – an asterisk of the oil pump,
2 – the oil pump,
3 – a lining,
4 – a cover of the oil pump,
5 – редукционный the valve,		 6 – a rotor,
7 – the case of the pump,
8 – a lining,
9 – маслоприемник

Unscrewing of a bolt of the tension device приводной chains of the oil pump of engine DOHC


PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To remove a belt of a drive of the generator.
3. To weaken a bolt of fastening of a pulley of a cranked shaft. For an exception проворачивания a cranked shaft at pulley unscrewing it is necessary to fix a flywheel for teeths of a gear wreath or to include the fifth transfer and to the assistant to press against the stop a foot brake.
4. For access improvement to remove a radiator as it is difficult to remove a pulley of a cranked shaft at the established radiator.
5. On engines with system of injection of fuel to remove a ventilation hose картера, the memory chamber and the case of the air filter.
6. Partially to unscrew a bolt of fastening of a pulley of a cranked shaft and, using a stripper, to remove a pulley. Stripper captures should rest against a metal part of a pulley.
7. To unscrew 11 bolts of fastening and to remove the bottom cover газораспределительного the mechanism. To remove rubber consolidation.
8. To unscrew a bolt and to remove натяжитель chains of a drive of the oil pump.
9. To unscrew a bolt of fastening of an asterisk on the oil pump and to remove an asterisk together with a chain.
10. To unscrew 4 bolts (are specified by arrows) and to take from the block of cylinders the oil pump.

Installation
PERFORMANCE ORDER
1. Carefully to clear interfaced surfaces of the block of cylinders and the oil pump.
2. To fill in in the pump engine oil, to establish on the pump a new lining, to establish on the block of cylinders and to screw fastening bolts, having tightened their demanded moment.
3. The further operations are made in sequence of return to removal.