Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
+ 3.2. Engine DOHC
+ 3.3. Engine V6
- 3.4. Ignition and engine management systems
3.4.1. A technical characteristics
+ 3.4.2. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.4. Ignition and engine management systems
| THE GENERAL DATA |
The ignition system is intended for ignition of a working mix in engine cylinders by the spark category which should be created during strictly certain moment.
The system of ignition ESC II is established on engines with the carburettor and includes the ignition coil, the distributor of ignition with the built in gauge of number of turns of the engine, the electronic block of management, a spark plug and gauges of temperature of a cooling liquid, depression and neutral position of the lever of the selector of an automatic transmission.
The system of ignition ESC IV is established on engines with system of injection of fuel and includes the ignition coil, the distributor of ignition with the built in gauge of number of turns of the engine, the electronic module (controller), spark plugs and gauges of temperature of a cooling liquid, neutral position of the lever of the selector of an automatic transmission, position throttle заслонки and absolute pressure.
Engine V6-24 with working volume 2,9 дм3 is equipped by system of ignition without the ignition distributor.
Safety rules
In order to avoid defeat by an electric current it is forbidden to touch high-voltage wires at the working engine.
Categorically it is forbidden to connect a control lamp or the condenser to the plug of 1 coil of ignition.
All connections of measuring devices to make only at the switched off ignition.
At compression check to remove the central wire from the distributor of ignition and to connect it to an additional candle fixed by the case on weight.
Carrying out of electrowelding works to make at the switched off ignition and the disconnected accumulator.