FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
- 13. A body
   13.1. Care of a body
   + 13.2. A cowl
   + 13.3. Doors
   + 13.4. External elements of a body
   + 13.5. Salon elements
   - 13.6. Heating and ventilation system
      13.6.1. Removal and installation of the block of management by a heater
      13.6.2. Removal and installation of cables of management of a heater
      13.6.3. Removal and heater installation
      13.6.4. Dismantling and heater assemblage
      13.6.5. Removal and installation of air lines of a heater
   + 13.7. The conditioner
+ 14. An electric equipment


59ff046c



13.6. Heating and ventilation system
THE GENERAL DATA

Fresh air arrives in salon through an air inlet lattice before a windscreen and moves the heater fan in car salon. Air passes through a heater and goes by means of system заслонок, operated cables, to nozzles of system of heating and ventilation. For heating of air cold air passes through a heater radiator. The radiator is located in the case of a heater and heats up a hot cooling liquid.

For increase in a stream of air the three-high-speed fan is used. For work of the fan with various speed depending on switch position consistently with the fan engine ballast resistance join.

Resistance are located on a fan payment. At failure of any of resistance replacement of all payment is required. The heater and the fan are established in salon under the panel of devices.