FORD SCORPIO

1985-1994 of release

Repair and car operation

13.6.3. Removal and heater installation

THE CARS MADE TO 04.1992 YEARS

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. The prevention The information in electronic memories is thus erased from memory. 2. To remove pressure in cooling system, having unscrewed a cover of a broad tank. 3. To press branch pipes of a supply of a cooling liquid to a heater. 4. To disconnect from branch pipes on a partition two heating hoses, thus the cooling liquid which is necessary for collecting in a vessel will follow from a heater. 5. To merge a maximum quantity of a cooling liquid from a heater radiator, blowing it. 6. To remove from a partition of a motor compartment a plate of branch pipes of a radiator and a lining. 7. To remove the central console and a covering for providing of access to a cable of management of a heater. 8. To remove a combination of devices from the panel of devices. 9. To remove the top part from the panel of devices. 10. To disconnect an air line from the heater case. 11. To unscrew two nuts of fastening of the block of a heater. To involve the block in the car until branch pipes do not leave a partition of a motor compartment, then to shift the block aside. 12. Installation is made in sequence, return to removal. 13. To add a liquid in cooling system.

THE CARS MADE ABOUT 04.1992 YEARS

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. The prevention The information in electronic memories is thus erased from memory. 2. To merge cooling liquid from cooling system. 3. To weaken clips and disconnect submitting and returnable hoses from a radiator. 4. To unscrew two screws of fastening of a protective plate of a radiator and to remove a lining from a partition of a motor compartment. 5. To remove the panel of devices. 6. To disconnect a plait of wires of the panel of devices for access to latches of nozzles размораживателя glasses. 7. To unscrew the screw with a nut and to disconnect each nozzle размораживателя a windscreen from a heater (arrows specify fastenings of nozzles). To unscrew two nuts and to disconnect the central nozzle from a heater at level of eyes. 8. To unscrew two nuts and then to disconnect the right nozzle at level of eyes from a heater. To repeat similar actions for the left nozzle. 9. For a detachment of back nozzles of heating of feet from a heater to remove an axis (it is specified by an arrow) from скобы, keeping a nozzle, at the same time supporting an external part скобы behind. The prevention If not to support скобу behind, it will fall in a nozzle after axis extraction. That it then to get, it is required to remove the ventilating channel for what it is necessary to remove lobbies of sitting and to lift a rug. 10. To disconnect a socket from the block of management of a heater. 11. To unscrew two nuts of fastening of a heater to a partition of a motor compartment and cautiously to remove a heater. 12. Installation is made in sequence, return to removal. 13. To add a liquid in cooling system.