FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
- 2. Maintenance service
   2.1. Periodicity of service of cars
   2.2. Each 10 000 km or once a year
   2.3. Each 40 000 km
   2.4. Each 60 000 km or in 2 years
   2.5. Check of level of engine oil
   2.6. Engine oil and filter replacement
   2.7. Places of possible leaks of engine oil and their definition
   2.8. Check of level and replacement of a cooling liquid
   2.9. Check of tightness of system of cooling
   2.10. Spark plugs
   2.11. Replacement of the air filter
   2.12. Replacement of the fuel filter
   2.13. Replacement of the valve of ventilation картера the engine
   2.14. Liquid check in air central air
   2.15. Check of level of oil in a transmission
   2.16. Check of level of oil in the back bridge
   2.17. Check of a condition of a protective cover of a power shaft
   2.18. Adjustment of a brake tape in an automatic transmission
   2.19. Check of a condition forward and back brake колодок
   2.20. Check of level and replacement of a brake liquid
   2.21. Check of a condition of a suspension bracket
   2.22. Check of level of a liquid in system of the amplifier of a steering
   2.23. Clearing of a drain for a condensate formed at work of the conditioner
   2.24. Recommendations about engine oils
   2.25. Specifications
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

2.8. Check of level and replacement of a cooling liquid

THE GENERAL DATA

Stopper plum of a cooling liquid on a radiator (engine V6)

The stopper plum of a cooling liquid is specified by an arrow.

The screw of removal of air on the top part of the thermostat (engine OHC)

The screw of removal of air is specified by an arrow.

If as a cooling liquid the concentrate mix "Super Plus 4" is used and water it is not required to make replacement of a cooling liquid.

Check of level of a cooling liquid is necessary for making constantly, but is not more rare than 1 time a month.

For доливки to apply only cooling liquid, that is a mix of the distilled water and antifreeze.
The prevention
In case of emergency it is possible to add and pure water, but thus in the shortest terms it is necessary to modify density of a cooling liquid or to replace it.

Level of a cooling liquid should be in a broad tank between labels "MIN" and "MAX" on the cold engine.

Cold cooling liquid to add only in the cold engine.

Volume of a cooling liquid

Engine OHC
8 l

Engine DOHC with the carburettor
7,9 l

Engine DOHC with fuel injection
7,3 l

Engine V6
8,5 l

The diesel engine till September 93г.
11,0 l

The diesel engine after September 93г.
7,0 l

Replacement of a cooling liquid to make every 2 year.

PERFORMANCE ORDER

1. To unscrew a cover of a broad tank.
The prevention
To unscrew a cover it is possible only at temperature more low 40 ° With, otherwise it is possible to get serious burns.

2. To establish under a radiator the corresponding container.

3. In car salon to establish a regulator of temperature of a heater in position of the maximum temperature.

4. To unscrew a stopper plum of a cooling liquid in the bottom part of a radiator and to merge a liquid.

5. To establish under the block of cylinders the corresponding container.

6. On the block of cylinders to unscrew a bolt plum of a cooling liquid and to merge a liquid.

7. After end plum to wash out cooling system, directing a stream at its finest through a broad tank, and to continue washing until pure water does not appear from an exit of the bottom tank of a radiator.

8. After system washing to screw up into place drain stoppers.

9. Filling of system of cooling to make through a mouth of a broad tank until allocation of air bubbles will stop.

10. To start the engine and to warm up it to working temperature. In the course of engine warming up to supervise level of a cooling liquid and if necessary to add.
11. To establish a cover of a broad tank.
12. After engine cooling to check up level of a cooling liquid.