FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   - 3.5. Diesel engines
      3.5.1. A technical characteristics
      3.5.2. The repair which is not demanding removal of the engine
      3.5.3. Check and adjustment of backlashes of valves
      + 3.5.4. Fuel system
      + 3.5.5. A head of the block of cylinders
      3.5.6. Removal and engine installation
      + 3.5.7. Dismantling, repair and engine assemblage
      3.5.8. Турбокомпрессор
      + 3.5.9. Greasing system
      + 3.5.10. Cooling system
      3.5.11. Typical malfunctions of the engine
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



3.5.8. Турбокомпрессор
THE GENERAL DATA

Турбокомпрессор


The pipeline of giving of oil to турбокомпрессору


Removal

PERFORMANCE ORDER
1. To remove a negative wire from the accumulator.
2. To remove protection картера and a mudguard.
3. To unscrew nuts and to disconnect a reception exhaust pipe with турбокомпрессора.
4. To disconnect a returnable oil tube from турбокомпрессора.
5. To remove a branch pipe of giving of air with турбокомпрессора.
6. To remove a branch pipe connecting collector and турбокомпрессор.
7. To remove the pipeline of giving of oil to турбокомпрессору.
8. To unscrew four bolts of fastening турбокомпрессора to a final collector and to remove турбокомпрессор lowering it downwards a motor compartment.
9. Carefully to clear interfaced surfaces on a collector and турбокомпрессоре.

Installation

Installation is made in sequence, return to removal. Thus it is necessary to pay attention to some features:

   – It is obligatory to establish new linings;
   – After installation турбокомпрессора to remove a socket of a food from the electromagnetic valve on the fuel pump of a high pressure. To turn the engine a starter until the control bulb of pressure of oil will not go out. It is necessary that oil has arrived to bearings турбокомпрессора, otherwise they can fail.

Start of the engine after major repairs
PERFORMANCE ORDER
1. After engine installation in the car to check up level of oil and cooling liquid.
2. To remove a socket from the electromagnetic valve of a stop of the engine and to turn the engine a starter while the lamp of emergency pressure of oil will not go out. To connect a socket to the electromagnetic valve of a stop of the engine.
3. To start the engine and to check up tightness of all systems. Дымление the engine is the normal phenomenon as there is a burning out of oil got on a detail at engine assemblage.