Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
5.1. A technical characteristics
5.2. Fuel
5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
+ 5.4. System of giving of air
+ 5.5. Carburettor PIERBURG
+ 5.6. Carburettor WEBER 2V
- 5.7. Carburettor WEBER 2V TLD
5.7.1. Removal and carburettor installation
5.7.2. Adjustment of turns of idling and quality of a mix
5.7.3. The needle valve поплавковой chambers
5.7.4. The vacuum device of a drive throttle заслонки the secondary chamber
5.7.5. Replacement of a diaphragm of the valve экономайзера
5.7.6. The automatic starting arrangement
5.7.7. Adjustment of turns of fast idling
5.7.8. Removal and installation демпфера throttle заслонки
5.7.9. Adjustment
+ 5.8. System of injection of fuel
5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
5.7. Carburettor WEBER 2V TLD
| THE GENERAL DATA |
Carburettor Weber 2V TLD is identical to carburettor Weber 2V, is established on engines DOHC, but has following differences from carburettor Weber 2V:
– Throttle заслонка the secondary chamber copes vacuum;
– It is established fuel запорный the valve;
– It is established air заслонка with electrowarmed up starting automatics and with vacuum and mechanical systems приоткрывания "pull down";
– демпфер throttle заслонки демпфирует sharp closing заслонки also reduces toxicity of exhaust gases. The pusher copes vacuum from an entrance collector. When the throttle opens, the vacuum puts in action a pusher which opens a throttle more than at an idling position. When the throttle is closed, демпфер slows down throttle closing. It reduces quantity of the burnt down fuel mix getting to the engine when заслонка it is closed, reducing thus the maintenance WITH;
– There is no step-by-step engine, and idling turns are established manually by means of the adjusting screw.