FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   - 5.7. Carburettor WEBER 2V TLD
      5.7.1. Removal and carburettor installation
      5.7.2. Adjustment of turns of idling and quality of a mix
      5.7.3. The needle valve поплавковой chambers
      5.7.4. The vacuum device of a drive throttle заслонки the secondary chamber
      5.7.5. Replacement of a diaphragm of the valve экономайзера
      5.7.6. The automatic starting arrangement
      5.7.7. Adjustment of turns of fast idling
      5.7.8. Removal and installation демпфера throttle заслонки
      5.7.9. Adjustment
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



5.7.6. The automatic starting arrangement
THE GENERAL DATA

The mechanism of starting automatics of carburettor Weber 2V TLD

1 – the top operating side scene заслонки,
2 – a returnable spring of a cam of fast idling,
3 – the plug,
4 – an axis of the lever,
5 – a side scene,
6 – the lever

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator and the case of the air filter.
2. To uncover the carburettor.
3. To note an arrangement of adjusting labels, to unscrew 3 screws of fastening of a flange, to remove a flange and a starting arrangement cover.
4. To take shielding ring.
5. To unscrew three screws of the case заслонки, in view of that, probably, it will be necessary to disconnect a returnable spring of a cam of fast idling to get access to one of screws; then to disconnect a side scene заслонки from the operating lever and to remove the starting arrangement.
6. To establish the lever throttle заслонки in position of full opening.
7. To move поводковый the starting arrangement lever upwards before full closing air заслонок and to release the lever of a drive throttle заслонок.
8. To unscrew three screws of fastening, to uncover a vacuum diaphragm and to take a diaphragm.
9. Assemblage is made in sequence, return dismantling.