FORD SCORPIO

1985-1994 of release

Repair and car operation

9.3.2.6. Removal and installation of the pump of the amplifier of a steering

THE GENERAL DATA

The hydraulic pump of the amplifier of a steering

1 – the pump, 2 – the bringing pipeline, 3 – the pressure head pipeline, 4 – by-pass the pipeline, 5 – a tank, 6 – a pulley, 7 – a flange, 8 – the bearing, 9 – a power shaft, 10 – a rotor, 11 – a ring

ALL PETROL ENGINES, EXCEPT DOHC

Sharnirnyj bolt of fastening of the pump of the steering amplifier on engine V6

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. 2. To establish under the hydraulic pump the corresponding container. 3. To close the generator a polyethylene film so that on it the liquid from system of the amplifier of a steering has not got. 4. To wipe places round connections, then to disconnect pipes of a high pressure and return pipes from the pump and a tank. 5. On the pump to weaken bolts of fastening of a pulley, to remove клиновой a belt and a pulley. 6. To unscrew bolts of fastening and regulation of the pump and to remove the pump.

ENGINES DOHC

Three bolts of fastening of the pump, accessible after unscrewing and removal of a pulley of the pump of engine DOHC

The pump is established on a suspension bracket on the forward right party of the block of cylinders. To improve access to the pump, to lift and fix on supports a forward part of the car.

PERFORMANCE ORDER

1. To establish under the hydraulic pump the corresponding container, to unscrew муфты the pipeline and to merge a liquid. 2. To remove приводной a belt. 3. To unscrew three bolts of fastening of a pulley and to remove a pulley from the pump. 4. To unscrew three bolts of fastening of the pump from a forward part of a suspension bracket and one bolt from a back part of a suspension bracket and to remove the pump. 5. For pump installation to execute actions in return sequence in relation to process of its removal. During this process it is necessary to pay attention on:      – A correct tension клиновых belts;      – Installation of new linings of connections of hydraulic pipelines;      – Correct filling with oil and removal of air from steering system.

CARS WITH DIESEL ENGINES

Places of connection of pipelines to the hydraulic pump

1 – the pressure head pipeline, 2 – the taking away pipeline

Bolts of fastening of the hydraulic pump

1 – an adjusting bolt, 2 – fastening bolts

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. 2. To lift a forward part of the car and to fix on supports. 3. To remove a forward mudguard under a motor compartment. 4. To establish under the hydraulic pump the corresponding container. 5. To weaken a collar, to remove taking away pipeline and to merge oil from system. 6. To unscrew a collar and to remove the pressure head pipeline. 7. On the pump to weaken bolts of fastening of a pulley, to remove клиновой a belt and a pulley. 8. To unscrew from the pump the adjustment lever.