FORD SCORPIO

1985-1994 of release

Repair and car operation

10.1.2.5. Replacement металлорезиновой lever plugs

PERFORMANCE ORDER

1. To remove the suspension bracket lever. 2. To unscrew a nut of a bolt of fastening of the lever to an engine mount cross-beam. 3. To remove шплинт and to unscrew from a rotary fist корончатую a nut of the spherical hinge of the lever and to squeeze out the spherical hinge of the lever from a rotary fist by means of a stripper. 4. To unscrew a nut of fastening of the stabilizer to the lever and to remove a forward metal washer and forward металлорезиновую the plug. 5. To disconnect and take the cross-section lever. 6. To arrange in a vice the adaptation 14.027 to take металлорезиновую the plug, the lever of a suspension bracket and the corresponding auxiliary plug. 7. To squeeze out металлорезиновую the plug from the lever. 8. To dip new металлорезиновую the plug of the hinge of the lever into soap water and to place this plug, the adaptation and the auxiliary plug in a vice. 9. To press металлорезиновую the plug into an aperture of the lever of a suspension bracket. 10. To insert the lever in a cross-beam of a suspension bracket and on the stabilizer end. To establish forward металлорезиновую the plug and a forward metal washer; to tighten the corresponding moment a nut of fastening of the stabilizer to the lever. 11. To insert into a rotary fist the spherical hinge of the lever, to tighten корончатую a nut the corresponding moment and to fix it шплинтом. The prevention If after a tightening корончатой nuts the corresponding moment cannot be inserted шплинт it is necessary to continue a nut tightening on such corner which will make possible an insert шплинта (it is impossible to unscrew корончатую a nut). 12. To insert a bolt of fastening of the lever to a cross-beam of an engine mount and to screw up new самоконтрящуюся a nut, without tightening it. 13. After car lowering to tighten a nut of a bolt of fastening of the lever to an engine mount cross-beam.