FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
- 10. Suspension brackets
   - 10.1. A forward suspension bracket
      10.1.1. A technical characteristics
      - 10.1.2. Service and repair
         10.1.2.1. A beam of a forward suspension bracket
         10.1.2.2. Removal and installation of a rack of a forward suspension bracket
         10.1.2.3. Dismantling and assemblage of a rack of a suspension bracket
         10.1.2.4. Removal and stabilizer installation
         10.1.2.5. Replacement металлорезиновой lever plugs
         10.1.2.6. Removal and installation of a rotary fist
         10.1.2.7. Installation of forward wheels
         10.1.2.8. Replacement of bearings of a nave of a wheel
   + 10.2. A back suspension bracket
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

10.1.2.6. Removal and installation of a rotary fist

THE GENERAL DATA

Fastening of a rotary fist of a wheel

1 – a bolt of fastening of the shock-absorber,

2 – a nut of fastening of steering draught,

3 – a nut of fastening of the stabilizer

Installation of the adaptation 14.026 at removal of the shock-absorber from a rotary fist of a wheel

Removal

PERFORMANCE ORDER

1. To weaken from the corresponding party of a nut of a forward wheel.

2. To lift and prop up the car and to remove a forward wheel.

3. To remove a support of a brake without a detachment of hydraulic pipelines and to suspend it to a body by means of a soft wire.

4. To unscrew the screw of fastening of a brake disk and to remove a disk.

5. To take шплинты and to unscrew корончатые nuts of spherical hinges from a rotary fist.

6. To squeeze out from a rotary fist the spherical hinge of steering draught by means of the adaptation 13.006.

7. To squeeze out the spherical hinge of the cross-section lever from a rotary fist by means of a stripper.

8. To unscrew from a rotary fist tightening a bolt of the bottom fastening of a rack of a suspension bracket.

9. To disconnect a rack of a suspension bracket from a rotary fist by means of the adaptation 14.026 and to take a rotary fist.

Installation

For installation of a rotary fist it is necessary to execute actions in return sequence in relation to removal process.