FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
- 11. Brake system
   11.1. A technical characteristics
   + 11.2. Forward brakes
   + 11.3. Back brakes
   11.4. Adjustment of a manual brake
   11.5. Removal of air from brake system
   - 11.6. Antiblocking system
      11.6.1. Functioning check
      11.6.2. Removal and installation of hydraulic knot of management
      11.6.3. Removal and installation of a brake pedal
      11.6.4. Removal and installation of the accumulator of hydraulic knot
      11.6.5. Removal and installation of the pump and the engine of hydraulic knot
      11.6.6. Replacement of the gauge of speed of rotation of a forward wheel
      11.6.7. Replacement of the gauge of speed of rotation of a back wheel
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

11.6.3. Removal and installation of a brake pedal

PERFORMANCE ORDER

1. To remove a negative wire from the accumulator.

The prevention
To remove pressure in the hydraulic accumulator of brake system. For this purpose it is necessary to switch off ignition and to press against the stop a brake pedal (about 20 times) while it does not become "firm".

2. To remove an upholstery under the panel of devices from outside the driver.

3. To remove a spring clip of fastening of a pedal of a brake (2) to a pusher of hydraulic knot (1).

4. To take a shaft of a brake pedal, moving it to the left before clearing of a brake pedal.

5. To remove a brake pedal, having noted an order of an arrangement of washers and linings.

6. Installation is made in sequence, return to removal.

7. After pedal installation to check up work of the switch of fires of braking.