FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   - 3.1. Engine OHC
      3.1.1. A technical characteristics
      - 3.1.2. Service and repair
         3.1.2.1. Engine adjustment
         + 3.1.2.2. The repair which is not demanding removal of the engine
         3.1.2.3. Removal and engine installation
         - 3.1.2.4. Engine repair
            3.1.2.4.1. Engine dismantling
            3.1.2.4.2. Identification of co-operating parts
            3.1.2.4.3. Engine assemblage
            3.1.2.4.4. Replacement of pistons
            3.1.2.4.5. Removal and installation of an intermediate shaft
            3.1.2.4.6. System газораспределения
            3.1.2.4.7. Start of the engine after major repairs
         3.1.2.5. Greasing system
         3.1.2.6. Ventilation system картера
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



3.1.2.4.6. System газораспределения
THE GENERAL DATA

Replacement of a sealing ring of a cam-shaft

PERFORMANCE ORDER
1. To disconnect from the accumulator a wire of weight and to merge a liquid from cooling system (subsection 4.2.1 see).
2. To disconnect from a radiator the top and bottom elastic pipeline.
3. To remove a casing of a gear belt. To weaken bolts of fastening of the tension device, to move its roller, overcoming resistance of a spring, and to tighten bolts of fastening of the tension device (fig. Removal of the tension device of a gear belt by means of a key 21.012 see).
4. To remove a gear belt.
5. To remove from a cam-shaft a pulley and a basic plate of longitudinal installation.
6. To remove a sealing ring of a cam-shaft by means of the adaptation 21.008 And.
7. To oil a new sealing ring of a cam-shaft, to establish it in the adaptation 21.009 And and to press a ring into a head of the block of cylinders.
8. To establish on distributive to a shaft a basic plate and a pulley.
9. To put on a gear belt, to establish on labels cranked and distributive shaft (fig. Adjusting signs on system газораспределения see).
10. To pull a gear belt by means of the tension device (fig. Removal of the tension device of a gear belt by means of a key 21.012 see).
11. To establish a casing of a gear belt.
To connect to a radiator elastic pipelines of system of cooling (top and bottom).
To fill system of cooling with a liquid and to remove from it air.
To connect to the accumulator a weight wire.

Removal and installation of a cam-shaft and installation газораспределения

These actions are described in section (subsection 3.1.2.2.3 and subsection 3.1.2.2.1 see).