Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
- 4. Cooling system
4.1. A technical characteristics
+ 4.2. Plums of a liquid and filling of system of cooling
4.3. Removal and radiator installation
4.4. Removal and thermostat installation
+ 4.5. The fan
4.6. The pump of system of cooling
4.7. The temperature gauge
4.8. A privodnoj belt of engine DOHC
4.9. The tension mechanism приводного a belt
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
|
ENGINES OHC
The pump of system of cooling and engine OHC thermostat
|
|
1 – the case of the thermostat,
2 – a lining,
3 – a sealing ring,
4 – the thermostat,
5 – a spring clip,
6 – крыльчатка the pump,
7 – a lining,
8 – the bearing,
9 – the case,
10 – a pulley nave |
| PERFORMANCE ORDER |
| 1. To disconnect from the accumulator a weight wire. |
| 2. To merge cooling system. |
|
3. To disconnect the top hose from the thermostat case on the forward party of a head of the block of cylinders. |
| 4. To unscrew bolts and to remove the case of the thermostat and a lining. |
|
|
| 5. To pick up a screw-driver a spring clip (drawing at the left) the thermostat and to take the thermostat together with a sealing ring (drawing on the right). |
| 6. To clear interfaced surfaces of the case of the thermostat and a head of the block of cylinders. |
|
7. Installation is made in sequence of return to removal, thus the arrow (it is shown by an arrow) thermostat stream should be directed to the engine. |
| 8. To start and warm up the engine, and also to check up tightness of connections of system of cooling. |
| 9. After engine cooling to check up and in case of need to add level of a cooling liquid in a broad tank. |
|
ENGINES DOHC
| PERFORMANCE ORDER |
| 1. To disconnect from the accumulator a weight wire. |
| 2. To merge cooling system. |
| 3. For access improvement to the thermostat on engines with system of injection of fuel to weaken collars and to lift the receiver, connecting chamber of an elevated pressure and an inlet collector. |
|
2. To merge cooling system. |
| 4. To disconnect hoses of a cooling liquid from the thermostat case. |
|
5. To disconnect a socket from the switch of the fan of the cooling established in the case of the thermostat. |
|
6. To unscrew three bolts and to remove the thermostat case. |
|
7. Installation is made in sequence of return to removal, thus the thermostat safety valve is necessary for establishing upwards (it is shown by an arrow). |
|
ENGINES V6
The thermostat acts in film in the course of removal of the water pump. |
|
