FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   - 5.4. System of giving of air
      5.4.1. Removal and installation of the air filter
      5.4.2. A temperature regulator
      5.4.3. The fuel pump
      5.4.4. Replacement of the fuel filter by engines with system of injection of fuel
      5.4.5. Removal and installation of a fuel tank
      5.4.6. Removal and installation of the gauge of measurement of level of fuel
      5.4.7. Removal and installation of the inertial switch of giving of fuel
      5.4.8. Removal and installation of a pedal of an accelerator
      5.4.9. Removal and installation of a cable of an accelerator
      5.4.10. A steam separator
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c Магнит глазной смотрите здесь.



5.4.2. A temperature regulator
THE GENERAL DATA

The vacuum diaphragm operating заслонкой of adjustment of temperature of air arriving in the engine

The vacuum diaphragm is specified by an arrow.

Thermovalve arrangement in the case of the air filter

The thermovalve is specified by an arrow.

On engines with the carburettor the temperature regulator maintains temperature of air arriving in the air filter, within 25–35 ° With.

Заслонка in a branch pipe of submitted air provides giving of hot or cold air. Заслонка copes a vacuum diaphragm, whiling away reacts to vacuum in an inlet collector. Vacuum receipt to заслонке is regulated by the thermovalve located in the case of the air filter.

Check

PERFORMANCE ORDER
1. To begin temperature regulator check it is necessary on the cold engine. At the switched off engine заслонка a temperature regulator should be completely closed. To define position заслонки it is possible both from outside the filter, and from outside an air inlet.
2. To start the engine and to check up that заслонка completely opens idling, opening giving of air warmed up by a final collector in the air filter.
3. In a case if after engine start заслонка a temperature regulator remains closed, it is necessary to check up a temperature regulator and a membrane.