FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   - 5.4. System of giving of air
      5.4.1. Removal and installation of the air filter
      5.4.2. A temperature regulator
      5.4.3. The fuel pump
      5.4.4. Replacement of the fuel filter by engines with system of injection of fuel
      5.4.5. Removal and installation of a fuel tank
      5.4.6. Removal and installation of the gauge of measurement of level of fuel
      5.4.7. Removal and installation of the inertial switch of giving of fuel
      5.4.8. Removal and installation of a pedal of an accelerator
      5.4.9. Removal and installation of a cable of an accelerator
      5.4.10. A steam separator
   + 5.5. Carburettor PIERBURG
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



5.4.7. Removal and installation of the inertial switch of giving of fuel
THE GENERAL DATA

Arrangement of the inertial switch of the fuel pump on models Estate

The inertial switch is shown by an arrow.

The inertial switch of giving of fuel stops fuel giving in system in case of failure. Giving stops by switching-off of a food of the fuel pump.

PERFORMANCE ORDER
1. To remove a wire of weight from the accumulator.
2. To open a luggage carrier door, to remove an upholstery of a luggage carrier and to disconnect a socket from the switch established near the drummer of the lock of a door (drawing at the left – early models, drawing on the right – late models).
3. To unscrew two screws of fastening and to remove the inertial switch of giving of fuel.
4. Installation is made in sequence of return to removal.