FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
- 5. Fuel system
   5.1. A technical characteristics
   5.2. Fuel
   5.3. Neetilirovannyj gasoline of engines V6, 2.4 and 2.9 дм3
   + 5.4. System of giving of air
   - 5.5. Carburettor PIERBURG
      5.5.1. Adjustment of turns of idling and quality of a mix
      5.5.2. Adjustment демпфера throttle заслонки the first chamber
      5.5.3. Adjustment of a starting backlash air заслонки
      5.5.4. Removal and carburettor installation
      5.5.5. Carburettor dismantling
      5.5.6. Carburettor assemblage
      5.5.7. Adjustment of fast idling
      5.5.8. Carburettor Pierburg changes 2V since September 1986 г
   + 5.6. Carburettor WEBER 2V
   + 5.7. Carburettor WEBER 2V TLD
   + 5.8. System of injection of fuel
   5.9. Removal and installation of an inlet collector
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



5.5.3. Adjustment of a starting backlash air заслонки
THE GENERAL DATA

Adjustment of the starting arrangement air заслонки

The starting arrangement is shown by an arrow.

PERFORMANCE ORDER
1. To remove the case of the air filter.
2. To unscrew the central bolt of fastening of the chamber for a cooling liquid and to remove the chamber. Under a head of a bolt and on chamber perimetre ring consolidations are established.
3. On the case of a bimetallic spring and the holder of the lever заслонки there are labels. In the absence of labels it is necessary to put them. To unscrew three screws keeping a ring clip, and to remove a clip and the case.
4. Completely to close air заслонку for what to turn against the stop clockwise the lever of a drive air заслонки and to fix it in this position by an elastic band.
5. To move the lever of a drive air заслонки to knot of a vacuum diaphragm of the starting arrangement. For this purpose to establish the screw of adjustment of idling on the top step of a cam.
6. To measure by means of a drill or a measuring core a backlash between an edge air заслонки and a carburettor wall. The backlash should be equal 3 mm.
7. If necessary, to spend adjustment, using 2 mm a key-shestigrannik.