FORD SCORPIO

1985-1994 of release

Repair and car operation

5.8.10. Removal and installation of a coal adsorber ENGINE DOHC 2,0 дм3 With the CATALYST

PERFORMANCE ORDER

Models till July, 1990 1. The coal adsorber settles down in a motor compartment on the right mudguard near to fastening of a rack of a suspension bracket. 2. To remove a wire of weight from the accumulator. 3. To unscrew 2 screws of fastening of a broad tank and to remove a tank from a coal adsorber. 4. Disconnect from top of a coal adsorber a vacuum hose. 5. To unscrew a fastening bolt, to take a coal adsorber from a motor compartment. 6. Installation is made in sequence, return to removal. Models since July, 1990 7. The coal adsorber (it is specified by an arrow) settles down behind the right back wheel where it is established on the bottom party of a body of the car. 8. To lift a back part of the car and to fix on supports. 9. To remove a wire of weight from the accumulator. 10. To disconnect a vacuum hose from top of a coal adsorber and to unscrew the fastening screw. 11. To raise a coal adsorber, to unhook from adjusting скобы and to take from the car. 12. Installation is made in sequence, return to removal.