FORD SCORPIO

1985-1994 of release

Repair and car operation

13.5.4. Removal and installation of the central console

THE CARS MADE TO 04.1992 YEARS

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. The prevention The information in electronic memories is thus erased from memory. Variant with usual furnish 2. To remove from a forward part of the console a rubber rug and заглушки screws. To unscrew two forward screws (are specified by arrows). 3. To remove the handle of the lever of a gear change, unscrewing it. 4. To remove an average shelf in front of the lever of a manual brake. 5. To unscrew the central screw (it is specified by an arrow) fastenings which is under заглушкой and two back screws. 6. To remove the console. 7. Installation is made in sequence, return to removal. Variant with the improved furnish 8. To remove a box for cartridges. To unscrew two screws (are specified by arrows), being under a cover, крепящих the switch panel. 9. To lift a back part of the panel, to disconnect sockets and to remove them. 10. To remove facing of a box for cartridges and a box which fastens two screws (are specified by an arrow). 11. To remove the back control panel, having unscrewed two screws in the top corners and having removed the handle of management of heating. To disconnect прикуриватель and other wires if is. 12. To unscrew two screws, крепящих management of a back heater. 13. To remove the handle of the lever of a gear change, unscrewing it. 14. To unscrew four remained screws (two in front (are specified by arrows) and on one from each party). 15. To remove the console, taking it from under the bottom covering of the panel of devices and the handle of a manual brake. 16. Installation is made in sequence, return to removal.

THE CARS MADE ABOUT 04.1992 YEARS

PERFORMANCE ORDER

1. To remove a wire of weight from the accumulator. The prevention The information in electronic memories is thus erased from memory. 2. To pick up a thin screw-driver external (1) and internal (2) overlays (are specified by arrows) gear change lever. 3. To remove a back cover of the panel, to take a box for cartridges and to unscrew two screws (are specified by arrows) panel fastenings. 4. To raise the central panel and to disconnect electric sockets (are specified by arrows). 4. To remove the switching panel. 5. To unscrew 7 screws (are specified by arrows) (two ahead, on one from two parties and three behind) fastenings of the central console. 6. To remove the central console and to disconnect an electric socket (it is specified by an arrow). 7. Installation is made in sequence, return to removal.