Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
+ 3.2. Engine DOHC
+ 3.3. Engine V6
+ 3.4. Ignition and engine management systems
- 3.5. Diesel engines
3.5.1. A technical characteristics
3.5.2. The repair which is not demanding removal of the engine
3.5.3. Check and adjustment of backlashes of valves
+ 3.5.4. Fuel system
+ 3.5.5. A head of the block of cylinders
3.5.6. Removal and engine installation
- 3.5.7. Dismantling, repair and engine assemblage
3.5.7.1. Dismantling
- 3.5.7.2. Engine assemblage
3.5.7.2.1. Installation of the back radical bearing
3.5.7.2.2. Installation of lateral sealants
3.5.7.2.3. Assemblage of knot the piston-rod
3.5.7.2.4. Selection of pistons for diameter of the cylinder
3.5.7.2.5. Assemblage of a drive of system газораспределения
3.5.7.2.6. The further actions on engine assemblage
3.5.8. Турбокомпрессор
+ 3.5.9. Greasing system
+ 3.5.10. Cooling system
3.5.11. Typical malfunctions of the engine
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.5.7.2. Engine assemblage
| THE GENERAL DATA |
Before engine assemblage to check up all details and to establish only pure and in a good technical condition.
To observe: demanded communications of co-operating details, a correct relative positioning of these details and their correct installation according to their designations.
To replace all linings and the spring washers protecting bolts from unscrewing.
To clear co-operating surfaces of linings and connected details. For clearing not to use abrasive materials and sharp adaptations. These surfaces cannot carry traces of blows, attritions or scratches.
Apertures of oil channels in the block of cylinders of the engine should be muffled the copper stoppers covered герметизирующей with paste Loctite Frenetanch.