FORD SCORPIO

1985-1994 of release

Repair and car operation


Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   + 3.2. Engine DOHC
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   - 3.5. Diesel engines
      3.5.1. A technical characteristics
      3.5.2. The repair which is not demanding removal of the engine
      3.5.3. Check and adjustment of backlashes of valves
      + 3.5.4. Fuel system
      + 3.5.5. A head of the block of cylinders
      3.5.6. Removal and engine installation
      - 3.5.7. Dismantling, repair and engine assemblage
         3.5.7.1. Dismantling
         - 3.5.7.2. Engine assemblage
            3.5.7.2.1. Installation of the back radical bearing
            3.5.7.2.2. Installation of lateral sealants
            3.5.7.2.3. Assemblage of knot the piston-rod
            3.5.7.2.4. Selection of pistons for diameter of the cylinder
            3.5.7.2.5. Assemblage of a drive of system газораспределения
            3.5.7.2.6. The further actions on engine assemblage
      3.5.8. Турбокомпрессор
      + 3.5.9. Greasing system
      + 3.5.10. Cooling system
      3.5.11. Typical malfunctions of the engine
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c Оптом и в розницу, гониоскоп -краснов -гольдман.


3.5.7.2.3. Assemblage of knot the piston-rod
THE GENERAL DATA

Installation of a persistent half ring of a cranked shaft

PERFORMANCE ORDER
1. To check up a rod condition.
2. To observe correct installation: deepenings at the bottom of the piston should be directed to the same party, as designations on a rod and its cover.
3. To grease with a thin layer of engine oil a piston finger and to establish it in the plug of a head of a rod.
4. Carefully to establish in piston flutes the spring lock rings fixing a finger in the piston.
5. Using the special adaptation, to establish rings on pistons the party designated by an inscription "Top", towards a bottom. Rings are delivered in a condition ready to installation. Rings should move freely in piston flutes, but without a notable backlash.
6. To arrange rings in piston flutes so that locks (cuts) of sealing rings have been displaced from each other in opposite sides on a corner 120 ° concerning a cut маслосъемного rings.