FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair
         7.3.2.1. The work description
         7.3.2.2. Check of level of oil in a transmission
         7.3.2.3. Check and washing of a hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in a transmission operating time
         7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
         7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
         7.3.2.7. Removal and installation of a vacuum regulator
         7.3.2.8. The hydraulic booster of back planetary transfer
         7.3.2.9. A centrifugal regulator of pressure of oil
         7.3.2.10. Replacement of a back sealing ring
         7.3.2.11. Removal and installation of the mechanism of a choice of transfers
         7.3.2.12. Removal and installation of draught of a choice of transfers
         + 7.3.2.13. Adjustment of a cable of mechanism Kick-down
         7.3.2.14. Removal and transmission installation
         7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



7.3.2.12. Removal and installation of draught of a choice of transfers
THE GENERAL DATA

Arrangement of clamps of fastening of draught of a choice of transfers

1 – a spring clamp,

2 – draught

Adjustment of length of draught of a choice of transfers

1 – an adjusting nut,

2 – an eye,

3 – a spring clamp

PERFORMANCE ORDER
1. To remove two spring clamps of draught of a choice of transfers and to remove draught.
2. At draught installation to establish the lever of a choice of transfers to position "D" (or "DE") to establish and fix draught on a transmission. Rotating an adjusting nut of change of length of draught, to establish such length of draught, that it was freely established on the lever of a choice of transfers then to fix its clamp.
3. To check up moving of the lever of a choice of transfers to all positions.
4. Moving should be free, with accurate fixing in each position, otherwise it is necessary to make additional adjustment of length of draught.