FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair
         7.3.2.1. The work description
         7.3.2.2. Check of level of oil in a transmission
         7.3.2.3. Check and washing of a hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in a transmission operating time
         7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
         7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
         7.3.2.7. Removal and installation of a vacuum regulator
         7.3.2.8. The hydraulic booster of back planetary transfer
         7.3.2.9. A centrifugal regulator of pressure of oil
         7.3.2.10. Replacement of a back sealing ring
         7.3.2.11. Removal and installation of the mechanism of a choice of transfers
         7.3.2.12. Removal and installation of draught of a choice of transfers
         + 7.3.2.13. Adjustment of a cable of mechanism Kick-down
         7.3.2.14. Removal and transmission installation
         7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



7.3.2.4. Check of pressure of oil in a transmission operating time
THE GENERAL DATA

Check of pressure of oil in an automatic transmission


PERFORMANCE ORDER
1. To connect a manometre for measurement of pressure of oil, with a tip with a female thread of the corresponding diameter, to картеру transmissions.
2. To arrange a manometre in the car so that its indications were visible from a place of the driver.
3. To heat up (in the course of car movement) oil in a transmission to normal working temperature.
4. To check up pressure of oil in a transmission in an engine operating time idling.
5. If pressure too low it is necessary to check up oil level, hydrokinetic transfer, and also the oil pump.
6. If pressure too high it is necessary to check up number of turns of the engine idling, the vacuum pipeline between the engine and a transmission drive, a vacuum regulator, hydraulic knot of management in a transmission, and also pressure of oil during test of an overload of the engine (see subsection 7.3.2.5).