FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair
         7.3.2.1. The work description
         7.3.2.2. Check of level of oil in a transmission
         7.3.2.3. Check and washing of a hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in a transmission operating time
         7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
         7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
         7.3.2.7. Removal and installation of a vacuum regulator
         7.3.2.8. The hydraulic booster of back planetary transfer
         7.3.2.9. A centrifugal regulator of pressure of oil
         7.3.2.10. Replacement of a back sealing ring
         7.3.2.11. Removal and installation of the mechanism of a choice of transfers
         7.3.2.12. Removal and installation of draught of a choice of transfers
         + 7.3.2.13. Adjustment of a cable of mechanism Kick-down
         7.3.2.14. Removal and transmission installation
         7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

7.3.2.9. A centrifugal regulator of pressure of oil

THE GENERAL DATA

Elements of a centrifugal regulator of pressure of oil

1 – грузик,

2 – a spring,

3 – the valve,

4 – the regulator case

Removal and installation

PERFORMANCE ORDER

1. To establish the car over the viewing channel or on the lift and to disconnect a wire of weight from the accumulator.

2. To unscrew two bolts and to remove an intermediate support карданного a shaft.

3. To disconnect a cross-beam of a suspension bracket from a transmission and being careful to lower a transmission.

4. To unscrew two bolts and to remove a speedometer drive.

5. To unscrew six bolts and to remove картер the transmission extension piece.

6. To unscrew two bolts of fastening (are specified by arrows) and to remove a centrifugal regulator of pressure of oil from a nave.

7. Installation is made in sequence, return to removal. At regulator installation to turn a shaft so that apertures for bolts of fastening of a regulator were below, thus the regulator spring should be between the valve and грузиком.