FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
+ 3. Engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
- 7. Transmissions
   + 7.1. A mechanical five-speed transmission of type
   + 7.2. A mechanical transmission of type МТ 75
   - 7.3. Automatic transmission А4LD
      7.3.1. A technical characteristics
      - 7.3.2. Service and repair
         7.3.2.1. The work description
         7.3.2.2. Check of level of oil in a transmission
         7.3.2.3. Check and washing of a hydrokinetic transmission
         7.3.2.4. Check of pressure of oil in a transmission operating time
         7.3.2.5. Test of an overload of the engine by hydrokinetic transfer
         7.3.2.6. Adjustment of a tape of a brake of forward planetary transfer
         7.3.2.7. Removal and installation of a vacuum regulator
         7.3.2.8. The hydraulic booster of back planetary transfer
         7.3.2.9. A centrifugal regulator of pressure of oil
         7.3.2.10. Replacement of a back sealing ring
         7.3.2.11. Removal and installation of the mechanism of a choice of transfers
         7.3.2.12. Removal and installation of draught of a choice of transfers
         + 7.3.2.13. Adjustment of a cable of mechanism Kick-down
         7.3.2.14. Removal and transmission installation
         7.3.2.15. Malfunctions of an automatic transmission
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

7.3.2.7. Removal and installation of a vacuum regulator

PERFORMANCE ORDER

1. To establish the car over the viewing channel or on the lift and to disconnect a wire of weight from the accumulator.

2. To unscrew two bolts and to remove an intermediate support карданного a shaft.

3. To disconnect a cross-beam of a suspension bracket from a transmission and being careful to lower a transmission.

4. To remove a vacuum hose from a vacuum regulator.

5. To unscrew a fastening bolt (it is specified by an arrow) an arm of a vacuum regulator and to remove an arm.

6. To remove a vacuum regulator together with a rod.

7. To grease fresh трансмиссионным with oil a new sealing ring and to establish it on the union of a vacuum regulator.

8. The further installation is made in sequence, return to removal. It is obligatory to check up oil level in a transmission and if necessary to finish to norm.