Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
- 3.2. Engine DOHC
3.2.1. A technical characteristics
- 3.2.2. The repair which is not demanding removal of the engine
3.2.2.1. A chain газораспределительного the mechanism and asterisks
- 3.2.2.2. A head of the block of cylinders
3.2.2.2.1. Removal of a head of the block of cylinders
3.2.2.2.2. Dismantling and assemblage of a head of the block of cylinders
3.2.2.2.3. Check of a head of the block of cylinders
3.2.2.2.4. Check of directing plugs of valves
3.2.2.2.5. Processing of saddles of valves in a head of the block of cylinders
3.2.2.2.6. Grinding in
3.2.2.2.7. Assemblage of a head of the block of cylinders
3.2.2.2.8. Installation of a head of the block of cylinders
3.2.2.3. Removal and installation of a back sealing ring of a cranked shaft
+ 3.2.3. Removal and installation of the engine without a transmission
3.2.4. Ventilation system картера
+ 3.2.5. Greasing system
+ 3.3. Engine V6
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.2.2.2.6. Grinding in
| THE GENERAL DATA |
Grinding in of valves is necessary for making with application only fine-grained polishing paste.
| PERFORMANCE ORDER | |
|
After the termination of process of grinding in all details carefully to clear of a dirt and paste and to check up a saddle and a valve plate. The continuous matte ring on both details which specifies width of a facet of the valve should be visible.