FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      - 3.2.2. The repair which is not demanding removal of the engine
         3.2.2.1. A chain газораспределительного the mechanism and asterisks
         - 3.2.2.2. A head of the block of cylinders
            3.2.2.2.1. Removal of a head of the block of cylinders
            3.2.2.2.2. Dismantling and assemblage of a head of the block of cylinders
            3.2.2.2.3. Check of a head of the block of cylinders
            3.2.2.2.4. Check of directing plugs of valves
            3.2.2.2.5. Processing of saddles of valves in a head of the block of cylinders
            3.2.2.2.6. Grinding in
            3.2.2.2.7. Assemblage of a head of the block of cylinders
            3.2.2.2.8. Installation of a head of the block of cylinders
         3.2.2.3. Removal and installation of a back sealing ring of a cranked shaft
      + 3.2.3. Removal and installation of the engine without a transmission
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



3.2.2.2.7. Assemblage of a head of the block of cylinders
PERFORMANCE ORDER
1. To grease with fresh engine oil directing plugs of valves.
2. To insert the valve on the place.
3. To establish on the valve the bottom basic plate of springs.
4. To wrap up flutes for crackers in the top part of the valve a piece of a sticky tape for protection from damage of working edges маслоотражательных caps at their installation.
5. To grease with fresh engine oil маслоотражательный a cap and, using tubular оправку, to establish on directing the valve.
6. To remove a sticky tape from a valve core.
7. To repeat this operation for other valves.
8. To establish springs and the top plates of springs.
9. Supporting the valve in the closed position by the special adaptation to compress springs of the valve and to establish crackers of valves.
10. To establish into place hydraulic pushers of valves.
11. To establish to the place of the inlet pipeline and a final collector.