FORD SCORPIO

1985-1994 of release

Repair and car operation



Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      - 3.2.3. Removal and installation of the engine without a transmission
         3.2.3.1. Engine removal
         3.2.3.2. Additional operations on engine removal on cars with АКП
         3.2.3.3. Additional operations on removal of the engine from a transmission
         3.2.3.4. Engine installation
         3.2.3.5. Engine dismantling
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and piston rings
         3.2.3.8. Piston fingers and rods
         3.2.3.9. A cranked shaft
         3.2.3.10. Radical and шатунные bearings
         3.2.3.11. A flywheel
         3.2.3.12. Engine assemblage
         3.2.3.13. Start of the engine after major repairs
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment


59ff046c



3.2.3.11. A flywheel
THE GENERAL DATA

To check up a flywheel on presence of damages, a flywheel wreath – on presence of deterioration and damages.

If the wreath has strongly worn out or on it there is an absent tooth, it is necessary to replace a wreath. The old wreath can be removed, having made has spent on drink between two teeths, and then to bring down a chisel.

Installation of a new gear wreath on a flywheel demands heating of a wreath to 204 ° S.Eto is carried out by uniform heating of a flywheel by a blowtorch until heated up surfaces will not get a light yellow shade.

The prevention

Not to overheat a wreath, differently it прочностные properties will be lost.


The wreath has an oblique inside of teeths which should be turned to a starter. When the wreath will be heated-up enough, quickly to establish it into place, if necessary to tap, and to cool a natural way.