FORD SCORPIO

1985-1994 of release

Repair and car operation

Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
   + 3.1. Engine OHC
   - 3.2. Engine DOHC
      3.2.1. A technical characteristics
      + 3.2.2. The repair which is not demanding removal of the engine
      - 3.2.3. Removal and installation of the engine without a transmission
         3.2.3.1. Engine removal
         3.2.3.2. Additional operations on engine removal on cars with АКП
         3.2.3.3. Additional operations on removal of the engine from a transmission
         3.2.3.4. Engine installation
         3.2.3.5. Engine dismantling
         3.2.3.6. Cylinders
         3.2.3.7. Check and restoration of pistons and piston rings
         3.2.3.8. Piston fingers and rods
         3.2.3.9. A cranked shaft
         3.2.3.10. Radical and шатунные bearings
         3.2.3.11. A flywheel
         3.2.3.12. Engine assemblage
         3.2.3.13. Start of the engine after major repairs
      3.2.4. Ventilation system картера
      + 3.2.5. Greasing system
   + 3.3. Engine V6
   + 3.4. Ignition and engine management systems
   + 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment

3.2.3.2. Additional operations on engine removal on cars with АКП

PERFORMANCE ORDER

1. In a motor compartment to unscrew the top bolts of fastening of a transmission to the engine. To note arrangements of the tyre of grounding, скоб a vacuum tube and a tube of a measuring instrument of level of oil in a transmission.

2. To unscrew on the left side of the block of cylinders a bolt of fastening of a tube of a measuring instrument of level of oil in a transmission.

3. Through an aperture for starter installation to unscrew four bolts of fastening of the converter of a twisting moment to приводному to a disk. For consecutive access to each bolt to turn a cranked shaft for a bolt of fastening of a pulley.

4. To prop up a transmission by means of the corresponding lift and a wide board and a few to raise a transmission.

5. From under the car to unscrew other bolts of fastening of a transmission to the engine.

6. At a detachment of the engine from a transmission it is necessary to watch that the twisting moment converter was reliably kept in картере transmissions.