FORD SCORPIO

1985-1994 of release

Repair and car operation

3.2.3.8. Piston fingers and rods

PERFORMANCE ORDER

1. To squeeze out on a press fingers of pistons. 2. To lay rods on a plate and to check up, whether they are deformed. 3. To establish the adaptation 21.014 in a vice and to extend against the stop its directing finger. 4. To establish in the same direction the piston a sign "Front", and also a rod an oil spray. 5. To insert against the stop directing finger into a piston aperture. 6. To press a piston finger into an aperture in stop on a piston opposite side so that its head it was made even to internal edge of foot. 7. To establish in the adaptation the remote plug corresponding to given type of the engine. 8. To put on a head of a rod signs the handle "thermochrome" (Faber-Castell 2815) and to heat up it while colour of a sign will not change on the colour corresponding to external colour of the handle. It means that the rod head has heated up to the temperature necessary for запрессовки of a finger in the plug of a head (260–300 °). 9. Quickly to transfer a rod and to place it in the piston on an adjusting shaft. To insert a piston finger against the stop. 10. To wait, while the rod will not cool down, and to check up correctness of connection of the piston with a rod. 11. Rods while in service the engine are not exposed to deterioration, however, in certain cases, such as engine jamming, they can be deformed. It can be noticed visually but if there are doubts, rods can be checked up and if necessary to replace.