Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
+ 3.2. Engine DOHC
- 3.3. Engine V6
3.3.1. A technical characteristics
3.3.2. The repair which is not demanding removal of the engine
3.3.3. Engine removal
- 3.3.4. Dismantling and check of details of the engine
3.3.4.1. Engine dismantling
3.3.4.2. Check of degree of deterioration of details of the engine
3.3.4.3. Axis knot коромысел
3.3.4.4. Pushers of valves and a bar of pushers
3.3.4.5. A camshaft
3.3.4.6. Heads of the block of cylinders
3.3.4.7. Cylinders
3.3.4.8. Check and restoration of pistons and piston rings
3.3.4.9. Piston fingers and rods
3.3.4.10. A cranked shaft
3.3.4.11. Radical and шатунные bearings
3.3.4.12. Distributive gear wheels
3.3.4.13. A flywheel
+ 3.3.4.14. Greasing system
3.3.4.15. Ventilation system картера
+ 3.3.4.16. Engine assemblage
3.3.4.17. Adjustment of backlashes of valves
3.3.4.18. Auxiliary details of the engine
3.3.4.19. Engine installation
3.3.4.20. Start of the engine after major repairs or restoration
+ 3.3.5. Changes in a design of engines V6 2,4 and 2,9 дм3
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.3.4.19. Engine installation
| THE GENERAL DATA |
Engine installation is made in an order, the return to removal, but, besides, to pay attention to following moments:
– Slightly to grease a primary shaft of a manual transmission;
– On cars with a manual transmission to check up, that the switching off clutch lever has been correctly located, and to keep it in this position, using a wire or a rubber strip to prevent its moving while the engine is established;
– On cars with an automatic transmission to check up, that the hydrotransformer has been completely connected to the oil pump;
– To adjust a tension приводных belts of the pump of the hydraulic booster of a steering, belts of the generator and the pump of a cooling liquid;
– To fill system of cooling and system of the hydraulic booster of a steering, and then to fill in in the engine oil.