Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
+ 3.2. Engine DOHC
- 3.3. Engine V6
3.3.1. A technical characteristics
3.3.2. The repair which is not demanding removal of the engine
3.3.3. Engine removal
- 3.3.4. Dismantling and check of details of the engine
3.3.4.1. Engine dismantling
3.3.4.2. Check of degree of deterioration of details of the engine
3.3.4.3. Axis knot коромысел
3.3.4.4. Pushers of valves and a bar of pushers
3.3.4.5. A camshaft
3.3.4.6. Heads of the block of cylinders
3.3.4.7. Cylinders
3.3.4.8. Check and restoration of pistons and piston rings
3.3.4.9. Piston fingers and rods
3.3.4.10. A cranked shaft
3.3.4.11. Radical and шатунные bearings
3.3.4.12. Distributive gear wheels
3.3.4.13. A flywheel
+ 3.3.4.14. Greasing system
3.3.4.15. Ventilation system картера
+ 3.3.4.16. Engine assemblage
3.3.4.17. Adjustment of backlashes of valves
3.3.4.18. Auxiliary details of the engine
3.3.4.19. Engine installation
3.3.4.20. Start of the engine after major repairs or restoration
+ 3.3.5. Changes in a design of engines V6 2,4 and 2,9 дм3
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.3.4.9. Piston fingers and rods
| THE GENERAL DATA |
Piston fingers are established in нагретые rods.
Usually replacement of piston fingers make at replacement of pistons.
Rods while in service the engine are not exposed to deterioration, however, in certain cases, such as engine jamming, they can be deformed. It can be noticed visually but if there are doubts, rods can be checked up and if necessary to replace.