Ford Skorpio
+ 1.1. Car identification
+ 2. Maintenance service
- 3. Engines
+ 3.1. Engine OHC
+ 3.2. Engine DOHC
- 3.3. Engine V6
3.3.1. A technical characteristics
3.3.2. The repair which is not demanding removal of the engine
3.3.3. Engine removal
- 3.3.4. Dismantling and check of details of the engine
3.3.4.1. Engine dismantling
3.3.4.2. Check of degree of deterioration of details of the engine
3.3.4.3. Axis knot коромысел
3.3.4.4. Pushers of valves and a bar of pushers
3.3.4.5. A camshaft
3.3.4.6. Heads of the block of cylinders
3.3.4.7. Cylinders
3.3.4.8. Check and restoration of pistons and piston rings
3.3.4.9. Piston fingers and rods
3.3.4.10. A cranked shaft
3.3.4.11. Radical and шатунные bearings
3.3.4.12. Distributive gear wheels
3.3.4.13. A flywheel
+ 3.3.4.14. Greasing system
3.3.4.15. Ventilation system картера
+ 3.3.4.16. Engine assemblage
3.3.4.17. Adjustment of backlashes of valves
3.3.4.18. Auxiliary details of the engine
3.3.4.19. Engine installation
3.3.4.20. Start of the engine after major repairs or restoration
+ 3.3.5. Changes in a design of engines V6 2,4 and 2,9 дм3
+ 3.4. Ignition and engine management systems
+ 3.5. Diesel engines
+ 4. Cooling system
+ 5. Fuel system
+ 6. Coupling
+ 7. Transmissions
+ 8. A kardannyj shaft and the back bridge
+ 9. A steering
+ 10. Suspension brackets
+ 11. Brake system
+ 12. Wheels and tyres
+ 13. A body
+ 14. An electric equipment
3.3.4.5. A camshaft
| THE GENERAL DATA |
At excessive deterioration it is necessary to replace camshaft bearings. As for installation of new bearings special tools are required, for performance of this work it is necessary to address on specialised servicing deport.
Camshaft wear tracks can be found out on necks of bearings or working ledges of cams. Teases on necks or damage of necks of bearings cannot be eliminated repolishing, in this case it is necessary to replace a cam-shaft.
On the top points of working ledges of cams roughnesses or traces выкрашивания can be found out. Small roughnesses can be eliminated thin grinding or processing by an emery paper.
It is necessary to notice that the surface of working ledges of cams is tempered, therefore after infringement of integrity of the tempered layer wear process will occur very quickly.