FORD SCORPIO

1985-1994 of release

Repair and car operation

3.3.4.16.6. Installation of a gear wheel and a cover of a drive of the distributive mechanism

PERFORMANCE ORDER

1. To establish a new sealing ring in a drive cover. 2. To check up шпоночные flutes on the end of a cranked shaft, they should be pure, on шпонках should not be an agnail. To establish шпонки in шпоночные flutes. 3. If the gear wheel of a cranked shaft acted in film, to establish it into place so that a gear wheel was up to the end established on a cranked shaft, thus it is possible to take advantage of a pipe of suitable diameter. For pressing it also it is possible to use a pulley and a bolt temporarily. 4. To establish a camshaft gear wheel on a shaft so that a label a core it was combined with a label on a gear wheel of a cranked shaft. Pay attention that on a gear wheel коленвала there are two labels, made a core, it is necessary to achieve coincidence to the necessary label. Thus шпоночные grooves are turned to each other. On later 2,4 and 2,8 дм3 engines the nylon gear wheel of a camshaft is established. 5. To establish a washer and a bolt of a gear wheel of a camshaft. To tighten a bolt according to the inhaling moment. 6. To clear a forward surface of an intermediate plate and an interfaced surface of a cover of a drive, then on both interfaced surfaces to put hermetic. 7. To establish on an intermediate plate a new lining and to establish a cover of a drive of the distributive mechanism on the block of cylinders. 8. To establish fixing bolts of a cover of a drive and to tighten them according to the inhaling moment. 9. To check up axial люфт a camshaft. 10. To define position of a sealing ring in a cover of the distributive mechanism, then to squeeze out old consolidation. 11. To clear a forward plane of a transitive plate and a plane of a cover of the distributive mechanism, then to cover both surfaces with hermetic. 12. To place on a transitive plate a new lining and to establish a cover of the distributive mechanism on the block of cylinders. To wrap bolts manually. 13. Having taken advantage of a calliper, to centre a cover of the distributive mechanism concerning a camshaft, up to the end to tighten bolts. 14. Establish a sealing ring on a cover of the distributive mechanism, and to insert it into place, by means of the plug and a bolt. 15. Remove ledges of a lining from connected surfaces oil картера.