FORD SCORPIO

1985-1994 of release

Repair and car operation

3.3.4.16.9. Heads of the block of cylinders, axes коромысел and an inlet collector

THE GENERAL DATA

Linings of a head of the block of cylinders and marks

Sequence of a tightening of bolts of fastening of a head of the block of cylinders

Sequence of a tightening of bolts of fastening of an inlet collector

PERFORMANCE ORDER

1. To grease pushers of valves with pure engine oil and to insert them into the block of cylinders. To watch that they were established on former places. 2. To check up that interfaced surfaces of the block of cylinders and heads of the block of cylinders owe the pure. 3. To establish new linings of heads of the block of cylinders on directing plugs on the block of cylinders. To watch a correct arrangement of linings. The left and right linings differ from each other. On linings there is an inscription "FRONT TORAHS" ("the forward top party"). 4. Cautiously to lower heads of the block of cylinders on the block of cylinders and to fix bolts. 5. In three steps, in certain sequence to tighten bolts according to the moments of an inhaling specified in subsection 3.3.1. 6. To grease bars of pushers with engine oil and to insert them into the block of cylinders. 7. To establish on heads of the block of cylinders маслоотражательные guards and to establish axes клапанных коромысел in gathering. 8. To insert adjusting screws of levers of valves into nests of bars of pushers. 9. Gradually to tighten fixing bolts of axes клапанных коромысел till the corresponding moment of an inhaling. 10. To grease external edge of a contact surface of heads of the block of cylinders and a contact surface of an inlet collector with hermetic for lining installation. 11. To establish into place a new lining of an inlet collector and to establish an inlet collector. 12. To establish fixing bolts of an inlet collector and to tighten them in four receptions till the necessary moment of an inhaling in certain sequence. 13. To adjust клапанные backlashes.